Installing Shield; Installing Edger Blade - Maruyama E23 Manual Del Propietario Y Operador

6. When the throttle cable is adjusted correctly, tight-
en the locknut.
7. Reinstall the air filter cover and tighten the knob.

Installing Shield

WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
Edger.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injur y.
HOW TO AVOID THE HAZARD
• Never operate the Edger without the
blade shield in place.
Debris Shield
Shield Stud
Hex
Nut
Lock
Washer
Flat Washer
Collar
Plate Stud
1. Install the collar onto the plate stud.
2. Install the shield onto the plate stud, making sure
the shield stud fits into the matching slot in the
plate.
3. Install the flat washer, lock washer and hex nut
onto the plate stud.
4. Install the flat washer and knob onto the shield stud.
All manuals and user guides at all-guides.com
Plate
Flat Washer
Knob
— US-14 —

Installing Edger Blade

CAUTION
POTENTIAL HAZARD
• If the Edger blade is not adequately
tightened, it can come loose from the
Edger during use.
WHAT CAN HAPPEN
• This may cause damage to property or
personal injur y.
HOW TO AVOID THE HAZARD
• Make sure the Edger blade is securely
fastened to the attaching shaft in the
gearcase.
Gearcase
Attaching Shaft
Boss Adapter
3 mm Hex Wrench
1. Install the boss adapter onto the attaching shaft out
of the gearcase.
2. Install the edger blade, clamping washer and blade
bolt.
Note: The blade bolt has left-hand threads.
3. Align the hole in the boss adapter with the hole in
the gearcase.
4. Insert the 3 mm hex wrench into the holes in the
boss adapter and gearcase to lock the attaching
shaft.
Edger Blade
Blade Bolt (left
hand thread)
Clamping Washer