Possible Problems And Solutions - Oursson RF1005 Manual De Instrucciones

CLEANING AND MAINTENANCE, Рiс. F
• Unplug the device.
• Wash the inner parts of the device with a soft cloth and
clean water with a detergent, then wipe everything with
a cloth and clean water and wipe dry.
• Contamination of the door gasket can cause damage
to it, so regularly clean it with a soft cloth and a small
amount of neutral detergent.
• Outer surface of the device must be cleaned with a
slightly damp or dry cloth.
• Do not rub with detergent the informational sticker in-
side the device, because printed information can be
erased. The information is necessary for service.
• Do not spill water on the electrical components of
the device, as well as air vents because of the dan-
ger of electric shock.

POSSIBLE PROBLEMS AND SOLUTIONS

Possible problems
Device isn't working.
Vibrating noise .
The temperature is not cold
enough
The interior lighting is not
working.
The compressor is operating for
a long period.
Water flows from the bottom of
the device.
Frost accumulated on the rear
side of the device.
Please check the possible problems before contacting a service center.
Specifications
Model
Refrigerant
Refrigerant weight
Reversible doors
Total capacity, L
Refrigerating chamber capacity
Power consumption class
Power consumption, kW•h/year, W•h/day
Climatic class
Level of noise
Temperature adjustment
Rated voltage
Storage and transportation temperature
Operating temperature from
Humidity Requirements
Class of protection
Dimensions HxWxL, mm
Weight, kg
* Products must be stored in dry, ventilated warehouses at a temperature not lower than -25°С.
Possible causes
• There is no voltage in the mains.
• The cord is plugged incorrectly.
The device is in unstable position.
• The door is not closed firmly.
• Not enough ventilation
• The device is not turned on.
• Burnt-out bulb.
• Ambient temperature is too high.
• The door is opened too often or
remains open.
The hole for water draining is
clogged
• There is hot or moisture food in
the device.
• High humidity of the
environment.
TRANSPORTATION, Рiс. E
• Make sure there are no children or animals in the
device.
• Move and transport the device only in the un-
loaded condition.
• It is recommended to move and place the device
in two, Pic. E-1
• Pack the device before moving it.
• When moving do not grab or pull the door or door's
handle.
• When moving the device you cannot tilt it more than on
45 degrees. Protect the device from excessive vibration
and hits. Pic. E-2.
• Please transport the device packed and in vertical po-
sition. Improper transportation may result in injury and
damage of the device.
Solutions
• Turn on the device.
• Check the main and the plug. If they are
working, call the service center.
• Adjust the position of the device.
• Move it if necessary.
• Make sure the door is firmly closed.
• Clean the vents.
• Turn on the device.
• Replace the bulb.
• Adjust the temperature of the room.
• Make sure the door is firmly closed.
Carefully clean the hole.
• Do not place hot or unpacked products into the
device.
• Adjust the humidity in the room.
RF1005
R600a
25 g
Yes
103
97
А+
110 kW, 300 W
N/SN/ST
less than 42 dB
from 0°C to +10°C
220-240 V~, 50 Hz
-25°C tо +35°C
+5°C tо +35°C
15-75% without condensate
I
835х486х536
23,5
13