Malfunctions And Errors - Nedap PR30S Manual De Instalación

6�2�4 Install Wizard
EN
The install wizard guides you through the setup of the system parameters.
To prevent accidental system parameter changes, the PowerRouter asks you to login (during commissioning the login is skipped).
The last 4 digits of the serial number on the rating label is used for the login code. Use the Up/Down buttons to set each digit and press the
YES button to confirm and go to the next digit until the last digit is set.
The following parameters can be set: Language, Country, Date & Time, AC alarm relay.
Install wizard procedure:
1. Enter the service menu
2. Select Install wizard
3. Press YES to enter Install wizard
4. Press YES to continue the wizard
5. Enter login code
6. Press YES to continue the wizard
The table below shows the AC alarm relay parameters which can be set during the Install wizard or the software installation tool.
AC alarm relay
(left relay)
AC low alarm
Minimum difference
between ON and OFF
setting is 15 V
AC high alarm
Minimum difference
between ON and OFF
setting is 15 V
6�2�5 Internet connection
This clause describes a check if your PowerRouter is connected to the internet.
The internet connection test procedure:
1. Enter the service menu
2. Select Internet connection
The display will show information about the internet status like: Internet connection status (ok, error, counting), Last date and time when the
PowerRouter was internet connected, IP number and status about firmware distribution.

7 Malfunctions and errors

This chapter provides information in case of a malfunction or error of the PowerRouter.
The PowerRouter will indicate the malfunction on the unit both by the LED indicators and on the display. The malfunction may be of any
kind, either inside the unit or somewhere in the PV system. The unit will not operate until the fault has been corrected. The different error
codes and possible causes are addressed in this section. Refer to myPowerRouter.com for the latest error list.
LED indication
In case of malfunction the LEDs will either be OFF or FLASHING as follows:
Operation
Operational
Charging
Grid
Error
* Requires service intervention
** Error may resolve itself; other module/functions active.
12
Description
ON: AC alarm relay will be activated if grid voltage below set
value
OFF: AC alarm relay will be de-activated if grid voltage
above set value
ON: AC alarm relay will be activated if grid voltage above set
value
OFF: AC alarm relay will be de-activated if grid voltage
below set value
LED LED: ON
color
blue when unit is operational
blue n.a.
blue when grid is connected
red when error (*)
Default
value
LED: OFF LED: FLASHING
when unit is off or error n.a.
n.a. n.a.
when no grid or off Grid available not connected
n.a. when one module / function down (**)
Minimum Maximum
value value
180 V 225 V
225 V 230 V
235 V 254 V
230 V 235 V