Blumfeldt 10031962 Manual De Instrucciones página 8

EN
8
Question
Anything to pay attention when I put on
the shell after its washed?
How do I adjust the firmness of the
lounger?
What to do when 1 air chamber has less
air than the other?
How to achieve Max. airtightness hours?
What to do when my lounger is
punctured?
PRODUCER
Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
Answer
Make sure the liner's 2 PE tubes are not
twisted Inside when you put on the shell.
after properly Installed, fill It up 1 or 2
times or shake It to make sure the end of
liner comes to the end of the shell.
One more roll or one less roll of the
security bar helps you adjust the firmness.
Inflate more air, mostly it will fix the
problem. if not, loosen the cords on top of
the backrest to Max. and fill it up, tighten
up the cords, this is to make sure the end
of liner comes to the end of the shell, and
It will solve the problem.
Do the 5 star one of above Step 4.and
make sure step 3 ls strictly followed.
Take off the shell, locate the hole, or fill
up the liner and locate the hole with soap
water if necessary(bubbles come up from
the hole). Use normal transparent tape
to glue the hole on both sides of PE tube.
then put on the shell when finished.