Chauvet Professional Rogue R1 Beam Guia De Inicio Rapido página 3

Rogue™ R1 Beam QRG
Replacing The
Fuse
Lamp
Replacement
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
1. Turn the fixture off and disconnect it from power.
2. Wait at least 15 minutes for the lamp to cool down.
3. Remove both head covers by removing 8 Phillips-head ¼-turn screws.
4. Orient the rear of the product so that the fan is facing upward.
5. Remove the 2 Phillips-head screws on the sides of the fan assembly.
6. Roll the fan assembly to the right to expose the lamp.
7. Using the lamp base, push the lamp down against the spring clips located on the
bottom, then roll the lamp out the top.
8. Unscrew the 2 wires connected to the lamp by the spade terminals.
9. Reverse the steps above to install the new lamp.
Please refer to the User Manual for more detailed instructions with images.
3
EN
¼-turn
Phillips-head
screws