How To Assemble Your Ceiling Fan - Fanimation INFLUENCER FP3075 Serie Manual De Instrucciones

1. Remove the hanger ball portion from the dowrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for
reinstallation in Step 6. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
the black, white, blue wires and
the downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.

How to Assemble Your Ceiling Fan

safety cable through
Downrod
Set Screw
Hairpin Clip
Downrod
Set Screws
and Nuts (2)
Downrod
Hairpin Clip
7
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black, White, Blue wires
and Safety Cable
Downrod Support
Figure 3
Set Screws and
Locking Nuts (2)
Clevis Pin
Figure 4