Starting And Stopping; Before Starting; Starting; Stopping - Husqvarna DM340 Manual De Instrucciones

Before starting

WARNING! Note the following before
!

starting:

The machine should be connected to an
earthed outlet socket.
Never use the tool without the ground fault
circuit interrupter delivered with the tool.
Check the ground fault circuit interrupter.
See instructions under the heading
Checking, maintaining and servicing the
machine's safety equipment.
Check that the mains voltage corresponds
with that stated on the rating plate on the
machine.
Ensure you stand firmly. Keep people and
animals well away from the working area.
Make sure that:
• Power switch, cord and electrical outlet are intact. If not,
they must be replaced by an authorised repairman.
• Cooling air vents are not blocked.
• The machine and its equipment are correctly installed.
• The stand is properly fixed and that the drill is properly
mounted on the stand.
• The drill is secured properly.
• Water cooling is undamaged and connected to the
machine.
• Use suitable drill bits depending on whether water or dry
drilling is being performed. In the event of uncertainty
contact your dealer, your service workshop or an
experienced operator.
• Prevent unintentional starting. Ensure the switch is in the
OFF-position before connecting to power source.
10 –
English

STARTING AND STOPPING

Starting
IMPORTANT! Changing gear may only be done when the
machine is switched off. Otherwise there is a risk of
damaging the gearbox.
1 Set the working speed by turning the drill spindle and at
the same time move the gear knob to the required
position.
2 Turn on the water cooling.
3 Start the machine by switching on the on-off switch.
Also press, if desired, the Smartstart

Stopping

WARNING! The drill bit continues to rotate
!
for a while after the motor has been switched
off.
Do not stop the drill bit with your hands.
Personal injuries can occur.
Switch the on-off switch off to stop the machine.
Cooling
Run the machine unloaded for a minute or two to cool the
motor.
TM
button.