Beper 50.000 Manual De Instrucciones página 8

Steam station Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
PARTS AND ACCESSORIES Fig.A
1- Boiler
2 - Iron boiler connection cable (supply cable + steam hose)
3 - Supply cable with plug
4 - Boiler on/off switch with pilot lamp
5 - Iron on/off switch with pilot lamp
6 - "Steam ready" pilot lamp
7- Iron stand
NOTICE
IRONING :
NOTE: Only iron on surfaces resistant to heater.
Make sure that the safety boiler cap is well closed, otherwise part of the steam will escape from this
opening. The steam ready pilot lamp switch on and off itself during the use ; this is the correct way and
shows that the appliance always contains the pressure.
When there is a lack of water into the tank, the "lack water" pilot lamp illuminates, turn off the iron and
open the safety boiler cap only when completely cool.
When used for the first time, clean the iron with a cloth (without any detergent).
Fill in the tank with water.
Press the iron switch on/off (5) and the on/off boiler button (4) to use the iron with steam system.
Select desired temperature with the thermostat knob (9).
When the thermostat pilot lamp (11) turn off, that means the temperature is reached and the iron ready to use
in dry iron system.
When the steam station is ready the steam ready pilot lamp (6) illuminates.
It takes about 8 minutes to the steam station to reach the desired temperature.
Press steam button (10) to get steam.
8 - Safety boiler cap
9 - Thermostat knob
10 - Steam button
11 - Thermostat pilot lamp
12 - Continuous steam button
13 - Steam adjustment
8