The Set Setting Menu - Sony VPL-CX11 Manual De Instrucciones

The SET SETTING
Menu
The SET SETTING menu is used for
changing the settings of the projector.
SET SETTING
STATUS: ON
INPUT-A: RGB
KEYSTONE MEMORY: ON
DIGITAL KEYSTONE: OFF
LANGUAGE: ENGLISH
INSTALLATION: FLR-FRONT
POWER SAVING: OFF
SIRCS RECEIVER: FRONT&REAR
LAMP TIMER: 00010h
Menu Items
STATUS (on-screen display)
Sets up the on-screen display.
ON: Shows all of the on-screen displays.
OFF: Turns off the on-screen displays
except for the menus, a message when
turning off the power, and warning
messages.
INPUT-A
Selects the RGB or component signal input
from the INPUT A connector.
Note
If the setting is not correct, "Please check
INPUT-A setting." appears on the screen and
the color of the picture becomes strange or the
picture is not displayed.
KEYSTONE MEMORY
Memorizes the data adjusted with DIGITAL
KEYSTONE.
DIGITAL KEYSTONE
Adjusts trapezoidal distortion of the picture
that may occur depending on the projection
angle.
GB 30

The SET SETTING Menu

INPUT-A
When the downside of the trapezoid is
longer than the upside
minus value.
When the upside of the trapezoid is longer
than the downside
value.
LANGUAGE
Selects the language used in the menu and
on-screen displays. Available languages are:
English, French, German, Italian, Spanish,
Japanese and Chinese.
INSTALLATION
Sets to reverse the picture horizontally or
vertically.
FLR-FRONT: The picture is not reversed.
CEIL.-FRT: The picture is reversed
horizontally and vertically.
FLOOR-REAR: The picture is reversed
horizontally.
CEIL.-REAR: The picture is reversed
vertically.
Note
In case of using a mirror, be careful of
installation since the picture may be reversed.
POWER SAVING
When set to ON, the projector goes into
power saving mode if no signal is input for
10 minutes.
SIRCS RECEIVER
Selects the remote control detectors (SIRCS
receiver) on the front and rear of the
projector.
FRONT & REAR: Activates both the front
and rear detectors.
FRONT: Activates the front detector only.
REAR: Activates the rear detector only.
LAMP TIMER
Indicates the total number of hours for which
the lamp currently used has been operated.
: Sets to a
: Sets to a plus