Safety Instructions - Roadstar HK-300S Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 11

SAFETY INSTRUCTIONS

IMPORTANT
The mains lead of this product is not replaceable by the user.
If the mains lead is damaged, it must only be replaced by an authorised dealer.
Before first use, fill with water to the maximum mark, bring to the boil and discard - this
will ensure that your kettle is perfectly clean.
Boiling water and steam can cause serious burns. Always place your kettle on a stable,
flat surface and only use the base supplied. Always allow the appliance to cool completely
before cleaning or storage.
Make sure that the voltage indicated on the rating plate (located
on the underside of the kettle) is the same as the supply voltage in your home. If not, do
not use the kettle and return it to your dealer.
After the kettle has switched off automatically, there may be a short delay before it can be
re-boiled - this is usually no more than 20 seconds.
The safety cutout will operate if you accidentally switch your kettle on when it is empty.
Wait 15 minutes for the cutout to reset before refilling with cold water.
Never immerse the kettle or base in water (or any other liquid) and do not allow water to
penetrate its electrical parts to prevent electrical hazards.
Ensure that the kettle and its mains cable are kept out of the reach of children and pets.
Close supervision is necessary when this appliance is used near children.
The outside surface will get very hot during use. Always take care when handling your
Always ensure that the kettle is switched off before removing from the base unit.
Beware of steam being emitted from the spout or lid, especially during refilling.
This kettle is intended for normal household use only.
This kettle is intended for boiling water only, nothing else.
It must not be used for anything other than its intended purpose.
Do not use this appliance outside.
Do not insert any objects into holes or slots in this appliance.
This appliance must not be placed on or near any objects that heat up (such as a gas
or electric hob).
Do not allow the mains lead to hang over the edge of the work surface, touch sources
of heat or become knotted.
Do not operate this appliance if the mains lead or plug are damaged, or if the appliance
malfunctions or is damaged in any way. Check the mains lead regularly for signs of
damage.
No user-serviceable parts inside - refer to qualified service personnel.
English
3
kettle.
English
4
FEATURES
A. Spout
B. Lid
C. Descaling filter
D. Power On/Off Switch
E. On/Off Indicator
F.
Base
Position the kettle on a stable flat
surface out of the reach of children and
close to a mains supply socket.
The underside of the base of the kettle
has a cable storage feature as shown
in Fig. 1. Unwind the length of cable
required to reach the mains socket.
Push the cable into one of the three
available slots in the base so that the
base will sit flat on the work surface.
G. Slots in Base for the Cable
H. Cable Storage
Make sure that the mains power cable is not placed where it can be inadvertently pulled or pinched.
G
Fig. 1
D
B
C
A
H
E
F

Publicidad

Tabla de contenido
loading

Tabla de contenido