Bushnell TROPHY 119774 Manual De Instrucciones página 8

INSTALLING THE BATTERIES AND SD CARD
Before you begin learning how to use your Trophy Cam HD Aggressor,
you will first need to install a set of batteries and insert an SD card. Although
that may only take you a minute, there are some important notes about both
batteries and SD cards you should be aware of, so please take the time to
read the following directions and cautions:
Loading Batteries
After opening the two latches on the right side of the
Trophy Cam HD Aggressor, you will see that the Trophy
Cam HD Aggressor has eight battery slots. For maximum
battery life, you should install a full set of batteries. The
Trophy Cam HD Aggressor may also be operated by just
four batteries installed in the first slots only (starting on the
top or left-see photos). Battery life will be shorter with 4
batteries, but the camera will operate normally. Whether
you use 4 or a full set, be sure to insert each battery with
correct polarity (negative or "flat" end against the long
spring of each battery slot).
Bushnell recommends using a full set of new lithium AA (Energizer brand)
®
or alkaline AA batteries. NiMh Rechargeable batteries are not recommended,
as the lower voltage they produce can cause operational issues.
You can also connect an optional Solar Panel accessory (model# 119756C
-please visit www.bushnell.com for more information) to the "DC In" jack
at the bottom of the Trophy Cam HD Aggressor (other external power
supplies should not be used, as the camera and/or display may not function
correctly). If the solar panel is connected and AA batteries are installed,
the Trophy Cam HD Aggressor will be powered by the solar panel's
rechargeable lith-ion battery, as long as it provides adequate voltage (if not,
the camera will switch to battery power). The solar panel's battery will power
the camera at night.
When the batteries become weak (or a device with insufficient power is
connected to DC In), the low-battery indicator LED will glow blue, indicating
the batteries should be changed (pg 7, Front View).
8