Turntable Installation - Candy MIC440VTX Manual De Instrucciones

Turntable Installation

Hub (underside)
Enamel tray
Turntable shaft
Important information about installing
• This appliance is NOT intended for use in a commercial
environment.
• Please observe the installation instructions provided and
note that this appliance should only be installed by a qualied
technician.
• The appliance is tted with a plug and must only be
connected to a properlyinstalled earthed socket.
• In case a new socket is needed, installation and cable
connection must only be done by a quali° ed electrician.
If the plug is no longer accessible following installation,
a pole disconnecting device must be present on the
installation site with a contact gap of at least 3 mm.
• Adapters, multiway strips and extension cords must not be
used. Overloading can result in fire.
Placement
• Danger! Do not disassemble this appliance. Touching internal components of this
appliance can cause serious personal injury or death.
Place the microwave oven on a firm,flat surface.
•
Make sure that there is surfi
•
and sides keep at least 10 cm free.
Do not cover the air vents.
•
The adjustable feet should not be r emoved.
•
Do not place the micr owave oven near a heat sour c e.
•
Transmitting and receiving equipment such as radios and televisions can af f ect the
•
operation of the micr owave oven.
GB
a. Never place the enamel tray upside down. The enamal
tray should never be restricted.
b. The enamal tray
c. All food and containers of food are always placed
on the enamel tray for cooking.
d. If enamel tray cracks or
nearest authorized service center .
The accessible surfacemay
be hot duringoperation.
cient ventilation around the micr owave oven. At the rear
GB-11
always be used during cooking.
must
breaks, contact your