Maintenance And Care - Schumacher SL1460 Manual Del Usuario

Generador eléctrico transportable

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

USING THE LED LIGHT

Choose from Normal, SOS and Emergency Flash modes.

1. Press the

button on the side of the unit for 2 seconds to turn on the LED light. The icon

2. Press the

button again for SOS mode.

3. Press the

button once more for emergency flashing.

4. Long press the

button for 2 seconds to turn off the LED light.

USING THE AC POWER OUTLETS

The SL1460 is equipped with a 200W modified sine wave inverter, which produces power for all electronic devices and appliances.

It is important to know the continuous wattage of the device you plan to use with the AC outlets. The unit must be used with devices drawing 200 watts or less.

Devices such as fans or electric motors require additional power to start (commonly known as the "starting" or "peak" power). The generator can supply a momentary surge

in wattage of as high as 400W for less than 1/10 of a second; however even devices rated less than the maximum 200 watts can exceed the inverter's surge capability and

cause an automatic overload shutdown.

Do not use the inverter with a product that draws a higher wattage than the inverter can provide, as this may cause erratic operation.

CAUTION: Always run a test to establish whether the inverter will operate a particular piece of equipment or device.

In the event of a power overload (noted with a flashing Warning icon), the inverter is designed to automatically shut down. This safety feature prevents damaging the

inverter while testing devices and equipment within the 200-watt range.

If powering more than one device, start one device at a time to avoid a power surge and/or inverter overload. The surge load of each device should not exceed the

inverter's Continuous Operation wattage rate.

You can use an extension cord from the inverter to the device without significantly decreasing the power being generated by the inverter. For best operating results, the

extension cord should be 16 AWG (1.31 mm

WARNING! RISK OF ELECTRIC SHOCK.

Incorrect operation of your inverter may result in damage and personal injury. The inverter output is 110V AC and can shock or electrocute the same as any ordinary

household AC wall outlet.

NOTE: The maximum continuous load is 200 watts. Do not use the AC outlets with a product that draws more than 200 watts, as this may cause erratic operation.

CAUTION:

• Do not connect an AC power source to the 110V AC outlets.

• Do not connect the unit's AC power cord to its 110V AC outlets.

NOTE: Do not power an AC device while charging the internal battery.

1. Connect your AC-powered devices or small household appliances to one or more of the unit's two AC outlets.

NOTE: Make sure the device to be powered is OFF before inserting the plug into the AC power outlet.

2. Press the AC Power button. The

will also show on the display.

NOTE: Extended operation of an AC device may result in excessive battery drain.

3. Recharge the unit when the battery level is below 40%.

ESTIMATED RUN-TIMES

APPLIANCE TYPE

ESTIMATED RUN TIME

Jig Saw

Projector

12V Heated blanket

12V Cooler

Drone

Television

Fan

Router

Table lamp

Laptop

LED lights

Camera

Radio

Tablet

Speaker

Smartphone

NOTE: Actual time may vary. Times are based on the internal battery being fully charged.