4 Operating
GB
4.4
Starting
application
44
Make sure that the skin areas to be treated are shaved, dry, clean and
free of creams, deodorants etc. Proceed as follows:
1.
Plug the end of the device plug of the power supply cable into the de-
vice
and the power supply plug into a socket. The readiness indica-
3
tor
flashes green.
9
2.
Press the ON/OFF button
light up at Level 1, the readiness indicator
device fan switches itself on. The device is now ready for positioning
on the skin.
3.
There are two ways for choosing the intensity:
a.
Set the intensity that you have tested and which is suitable for your
skin, by pressing the ON/OFF button
long, until the desired intensity (Level 1 to 4) is lit on the intensity dis-
play
( 1 LED for Level 1, 2 LED for Level 2, 3 LED for Level 3, 4 LED
2
for Level 4).
b.
or: Place the skin contact area
the build-in skin tone sensor, the device can automatically choose the
safest intensity level. The readiness indicator
manently and the level (1 - 6) is shown by the LED beside the trigger
button. If readiness indicator
to dark. Choose another area, if possible.
4.
Place the light area
trigger a light pulse. The skin contact area
(the readiness indicator
that a light pulse can be emitted by the device. When the pulse is emit-
ted, you will see a bright flash and may hear a clicking sound.
5.
Now place the device on another area of the skin while it charges for
the next light pulse.
6.
Then emit a new light pulse on the other skin area.
7.
Repeat this procedure for other planned skin areas.
8.
Switch the device off by pressing and holding the ON/OFF button
for about 3 seconds. Readiness indicator
1
and cooling fan will stop immediately.
. The intensity display
1
on the skin diretly. By taking use of
5
flashes red, skin tone of treated area is
9
onto the skin and press the trigger button
7
starts to illuminates green permanently), so
9
begins to
2
is blinking green and the
9
briefly in succession so
1
illuminates green per-
9
must lie fully on the skin
5
will flash green
9
to
4