Craftmade Enduro Guia De Instalacion página 5

5. Fan Assembly (with downrod).
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the 4in.
downrod provided to use with an extended
downrod (sold separately). [If you wish to use the 4in.
downrod, please proceed to instructions following the
dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top of
the downrod should be noted as having a set screw
hole; use this hole when setting the set screw). Insert
stop pin into top of extended downrod and raise
hanging ball. Be sure stop pin aligns with slots on
the inside of the hanging ball. Tighten set screw
securely.
WARNING: Failure to tighten set screw (on hanging
ball) completely could result in the fan becoming
loose and possibly falling.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will keep
the wires together when threading them through
the downrod.
Loosen yoke set screws and nuts and remove pin
and clip from motor hanging yoke. Slide downrod
through canopy and weatherproof yoke cover.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the downrod.
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nut securely. Lower
weatherproof yoke cover to motor housing.
Remove electrical tape from electrical wiring. Thread
each of the wires through a different hole in the
weatherproof hanging ball cover. Pull weatherproof
hanging ball cover down securely over hanging ball
(on downrod).
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
set screw
electrical wiring
hanging
ball
weatherproof
yoke cover
clip
page 4
stop pin
hanging ball
A
weatherproof
hanging ball cover
downrod
canopy
yoke set screw
set screw hole
B
pin
motor
housing