RIDGID R41222 Manual Del Operador página 31

ADJUSTMENTS
0° BEVEL ADJUSTMENT
See Figure 40.
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
 Unplug the saw.
 Loosen the bevel lock knob by turning the knob
counterclockwise.
 Square the blade to the miter table as described in the
Assembly section of this manual.
 If the blade is out of square, adjust by tightening or
loosening the 0° bevel stop screw using the Phillips
screwdriver end of the blade wrench.
 Retighten bevel lock knob. Recheck blade-to-table
alignment.
Your saw has several scale indicators. After squaring
adjustments have been made, it may be necessary to loosen
the indicators screws and reset them to zero. See Figures
21 and 22.
31 - English
BLADE
WRENCH
0° BEVEL
STOP SCREW
BEVEL LOCK
KNOB
Fig. 40