Display - Kenmore 580.74083 Manual Del Propietário

DISPLAY
I FANSPEED
• Every time you push this button, it advances the setting as follows: {High -* Low -* Med-* High}
REMOTE CONTROL SIGNAL
coo_ • RECEIVER
_ _ TEMPERATURE SETTING
F_ e • This button can automatically control the
_i_: • :"_"E_R temperature of the room.
The temperature can be set within a range
[-TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, Timer sets number of hours until shut-off.
• Every time you push Timer button, it advances the Timer setting
as follows: 1 Hour-_ 2 Hours........ 12 Hoursmaximum.
of 60°F to 86°F by increments of I°F.
POWER
• To turn the air conditioner ON, push the
button.
To turn the air conditioner OFF, push
the button again.
• This button takes priority over any other
button.
• When you first turn it on, the air conditioner is
on the High cool mode and the Temp. at 72°F.
- START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Every time you push Timer button, it advances the Timer setting as follows: 1 Hour -_ 2 Hours -*. ...... 12 Hours
maximum.
MODE
- Every time you push this button, it will shift among COOL, ENERGY SAVER and FAN.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is
needed.
In failure of electric power, the unit runs as previous setting operation.
HORIZONTAL AIR DIRECTION CONTROL VERTICAL AIR DIRECTION CONTROL
The horizontalair directionis adjustedby moving the vertical
louvers right and left with yourfingertips. (FIG. 15)
J
The vertical air direction is adjustedby movingthe horizontaI
louvers up anddown with your fingertips. (FIG. 16)
FIG. 15 FIG. 16
-10-