Troubleshooting - Vornado AVH2 PLUS Manual De Instrucciones

TROUBLESHOOTING

PROBLEM
The Unit fails to power on.
The Unit is not producing a
sufficient amount of heat.
12 English
POSSIBLE CAUSE AND SOLUTION
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker
/ ground fault circuit interrupter, or replace fuse. See IMPORTANT INSTRUCTIONS.
The unit has overheated. Automatic Safety Shut-Off has initiated. See RESET HEATER.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Ensure unit is set to High Heat and thermostat is set to highest temperature setting.
Close all doors and windows to trap heat.
Allow the unit to fully circulate the heat throughout the room; may take several minutes.