Final Assembly; Battery Connection; Wiring Diagram; Battery Type - Quantum ELM4L Manual De Usario

FINAL ASSEMBLY

Connect the polarized battery plug to
4
the charger board. Make certain that
the battery cable is routed to avoid
interference with the AC input
connector or other components.

Battery Connection

Note: some details may vary
battery connector

Battery Type

NiCd
LiFePO4 (LTP)
LiFePO4 (LTP HO)
LiFePO4 (LTP EHO)
INSTALLATION and WIRING (CONTINUED)
Housing attachment to mounting plate:
5
Make certain all wires and connectors are
routed to avoid interference with other
components. Align latch openings on
underside of housing with latch buttons
on mounting plate. Firmly push housing
straight onto mounting plate, making
certain all four latches are fully engaged,
and the housing is closely aligned to the
mounting surface.

WIRING DIAGRAM

Input from branch circuit. See label
on wire pair for voltage requirement
Total Load
6.6W
11.0W
22.0W
33.0W
Status Indicator LED
DC output to the remote units. See label on wire
pair for positive and negative polarity colors
Remote test Option
(standard with SDRT)
Federal Communications
Commission (FCC) Requirements:
This device complies with Part 15 of
the FCC Rules. This device may not
cause harmful interference.
Battery
Lamp
Lamp
Grey(LED-)
)
Yellow(LED+
Test Switch
page 3