Using Manual Channel Selection; Using Auto-Sync Channel Selection; D-Fi™ Signal Indicator - Chauvet DJ Obey 40 D-Fi 2.4 Manual De Usuario

Using Manual
Channel Selection
Using Auto-Sync
Channel Selection
D-Fi™ Signal
Indicator
Obey 40 D-Fi 2.4 User Manual Rev. 3
Manual Channel Selection is recommended. It tells the Obey™ 40 D-Fi 2.4 which channel to use for
D-Fi™ transmission. To use Manual Channel Selection for configuring D-Fi™, do the following:
1. Turn on all the other D-Fi™ products and set them all to the same channel. For instructions on
how to do this see each product's User Manual.
2. Turn off the Obey™ 40 D-Fi 2.4.
3. Set the board to the same channel as the products by setting the DIP switches. For more
information, see DIP Switch
4. Make sure DIP switch 6 is in the ON position.
5. Turn on the Obey™ 40 D-Fi 2.4. The Signal LED shows a fast blink.
Auto-Sync Channel Selection triggers a negotiation between the Obey 40 D-Fi 2.4 and all the other
D-Fi™ products to settle on a channel for D-Fi™ transmission. To use Auto-Sync for configuring D-
Fi™, do the following:
1. Turn on all the other D-Fi™ products and set them to Auto-Sync. For instructions on how to do
this see each product's User Manuals.
2. Turn off the Obey 40 D-Fi 2.4.
3. Set the board to Auto-Sync by setting DIP switch 5 to the OFF position.
4. Make sure DIP switch 6 is in the ON position.
5. Turn on the Obey 40 D-Fi 2.4. The Signal LED shows a solid light.
6. Press <Auto> and hold it down for at least 15 seconds. The Signal LED will begin a fast flash
when the board is communicating with the other products.
7. Continue holding <Auto> until all the other D-Fi™ products indicate that they are receiving. For
information on this, see each product's User Manuals.
CHAUVET® D-Fi™ products User Manuals can be found on the web site at
http://www.chauvetlighting.com/product-manuals-literature/.
The Obey 40 D-Fi 2.4 must be within 300 ft of the products receiving D-Fi™ and there must
be no significant obstructions between the Obey 40 D-Fi 2.4 and the other products.
· Set all the other products before setting the Obey 40 D-Fi 2.4.
· Make sure the Obey 40 D-Fi 2.4 is off before changing the DIP switch settings.
The D-Fi™ signal indicator provides information about the D-Fi™ status of the Obey 40 D-Fi 2.4.
The table below presents the various states of the indicator and what each state means.
Indicator LED
Solid Light
Slow Blink
Fast Blink
Table.
Mode
Auto-Syncing No connection yet. Waiting for Auto-Sync to finish
Receive Ready to receive
Receive Receiving data
Transmit Transmitting or ready to transmit.
Auto-Syncing Connection established. Auto-Sync is finished.
Meaning
Page 21 of 176