Assembly And Operation; Applications; Prior To Operation - Hitachi CJ 110MV Manual De Instrucciones

English

ASSEMBLY AND OPERATION

APPLICATIONS

Cutting various lumber and pocket cutting
Cutting mild steel plate, aluminum plate, and copper plate
Cutting plastics, such as phenol resin and vinyl chloride
Cutting thin and soft construction materials
Cutting stainless steel plate (With No. 97 blade)

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power source requirements
specified on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle
while the switch is in the ON position, the power tool will start operating immediately
and can cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of
sufficient thickness and rated capacity. The extension cord should be kept as short as
practicable.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact
a licensed electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause overheating, resulting in a serious
hazard.
5. Confirming condition of the environment:
Confirm that the work site is placed under appropriate conditions conforming to
prescribed precautions.
10
WARNING:
Damaged cord must be replaced or repaired.