Reliable ARIA 100SP Manual De Instrucciones página 11

from low to high, that you use.
CAUTION: Do not hold down the press for longer than 5 seconds. If using the steam
burst button, do not fully close the press down onto fabric. If you hold down the
press for too long, you may cause your garments to wrinkle because they are too
hot. If this should happen, spray down the garment with water and start over.
CAUTION: When using steam, do not hold the steam button for longer than 3
seconds. If steam is used for too long, you will cause the press temperature to drop
and will have to wait for it to reach the initial desired setting. The drop in tem-
perature cannot be avoided as the burst of steam cools down the pressing plate
instantly. By using steam in short bursts, you will help to eliminate the temperature
drop and thus be able to press quicker and more efficiently.
AUTO SHUT-OFF AND AUTO WAKE-UP
E1: A warning beep will signal if the pressing plate is left in a closed position
against the ironing board for more than 10 seconds. The press will stop heating
and the auto shut-off feature will initiate unless the pressing plate is restored to
the lifted position. The auto wake-up feature will then kick in. In some cases, you
will need to either turn the press off and then on again or unplug then re-plug the
unit in to reset its function.
CAUTION: Do not lock pressing plate and ironing board together as the press will
begin to beep. Only lock when storing.
E2: A warning beep will signal if the press is left unattended without use for
approximately 20 minutes. The press will stop heating and auto shut-off feature
will engage. In order to restore use, simply press the on/off button or press the
temperature control buttons to reset the press.
E3: A warning beep caused by a loose thermostat inside the machine.
CAUTION: If the E3 warning occurs, unplug your press and call customer service
for technical support.
WARNING: During initial use or after a long period of time without use, press the
08