Specific Safety Rules - Matco Tools MCL16CHRG Instrucciones De Operación

SAVE THESE INSTRUCTIONS!

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product
replace strict adherence to cordless product
safety rules. If you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
1 . Hold tool by insulated gripping surfaces when performing an
operation where the tool or accessory may contact hidden
wiring . Contact with a "live" wire will also make exposed
metal parts of the tool "live" and shock the operator .
2 . Be aware that this tool is always in operating condition,
because it does not have to be plugged into an electrical
outlet .
3 . Always be sure you have firm footing .
4 . Be sure no one is below when using the tool in high
locations .
5 . Hold the tool firmly and use both hands .
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
1 . Your new battery pack is not fully charged . You may need to
charge before use .
2 . Make sure the forward/reverse lever is in the neutral position
when installing or removing a battery .
3 . To remove a battery, depress the front tab and pull the
battery forward and the tool in the opposite direction .
4 . To install a 16V battery align the tool with the battery, place
the front of the tool about halfway up the battery, push
forward until click is heard indicating full installment .
4 .
Charging The Battery Pack
MCL16CHRG
MCL16CHRG 16V Li-ion Charger
Power On
(Green light flashes slowly)
Battery Low
(Red light stays illuminated)
Battery charged 80%
(Green light flashes rapidly)
Battery charged 100%
(Green light stays illuminated)
Battery Pack temperature is too hot
or too cold (Red light flashes slowly)
Battery Pack malfunction
(Red and Green lights stay
illuminated)
6 . Keep hands and hair away from rotating parts .
7 . Do not leave the tool running . Do not force tool to stay in the
"on" position . Operate the tool only when hand-held .
8 . Do not touch the drill bit, impact socket, any adapter, or
the workpiece immediately after operation; they may be
extremely hot and could burn your skin .
9 . Some material contains chemicals which may be toxic . Take
caution to prevent working dust inhalation and skin contact .
Follow material supplier safety data .
WARNING:
MISUSE or failure to follow the safety rules stated
in this instruction manual may cause serious
personal injury.
Charging The Battery Pack
1 . Battery may not charge when it is above a certain preset
temperature limit . Allow temperature of battery to cool before
charging .
2 . The charge process will take less than one hour .
3 . After charging, unplug the charger from the power source
and stow away in a safe place .
Tool Operation
• Plug charge station into a 100-240VAC outlet.
• If the battery pack is excessively hot or cold, the charger
will not begin charging and the red indicator on the charging
station will blink . When the battery returns to between 0°C
(32°F) and 50°C (122°F), the charger will automatically
begin charging . Ensure the charging ambient temperature is
between 0°C (32°F) and 40°C (104°F) .
• If both the red and green indicator lights are ON, the battery
pack does not comply or is defective . Please contact your
retailer .
• The charging process will take less than 60 minutes.
• Unplug the unit after the charging process and keep in a dry,
cool place .
Also available RSLIBCPC, Li-ion Charger Power Cord .
3 0717/14