Craftsman 247.888530 Manual Del Propietário página 14

To avoid engine problems, the fuel system should be
emptied before storage for 30 days or longer. Drain the
gas tank, start the engine and let it run until the fuel
lines and carburetor are empty. Use fresh fuel next sea-
son. See storage Instructions for additional information.
Never use engine or carburetor cleaner products in
the fuel tank or permanent damage may occur.
To Start Engine
WARNING
: Be sure no one other than
the operator is standing near the snow
thrower while starting or operating. Do not
operate this snow thrower unless the
discharge chute assembly has been
properly installed and is secured.
A. Electric Starter
For location of all the engine controls referred to in
this section, see Figure 17 inset. For illustration of
starting instructions, see Figure 18.
Before starting, make sure that the engine has suffi-
cient oil. The snow thrower engine is equipped with a
120 volt A.C. electric starter and recoil starter. The
electric starter is equipped with a three-wire power
cord and plug and is designed to operate on 120 volt
AC household current. Follow all instructions carefully.
Cold Start
NOTE: If the unit shows any sign of motion (drive or
augers) with the clutch grips disengaged, shut the
engine off immediately. Readjust as instructed in the
"Final Adjustments" section of the Assembly
Instructions.
WARNING: The electric starter must be
properly grounded at all times to avoid the
possibility of electric shock which may be
injurious to the operator.
Snow Spark Drive
Thrower Plug Levers
wire
Electric Connect Release Move to
Starter
Recoil Connect Release Move to
Starter
Starting Instructions At A Glance
Throttle Ignition Choke
control Key
Push to Move to
FAST snap in FULL
Push to Move to
FAST snap in FULL
• Determine whether your house wiring is a three-
wire grounded system. Ask a licensed
electrician if you are not certain.
WARNING: If your house wiring system is
not a three-wire grounded system, do not use
this electric starter under any conditions.
• If your house wiring system is grounded and a
three-hole receptacle is not available at the point
the snow thrower starter will normally be used,
one should be installed by a licensed electrician.
Insert key
Move
choke
Move
throttle
• When connecting the power cord, always
connect cord to starter on engine first, then plug
the other end into a three-hole grounded
receptacle.
• When disconnecting the power cord, always
unplug the end from the three-hole, grounded
receptacle first.
• Attach spark plug wire to spark plug.
Power Primer
Cord
Connect —
to source
— Prime
14
Connect spark
plug wire
Prime
Push
button
Connect cord
Recoil
starter
Figure 18
Starter After starting
Push 1. Release button
button 2. Move Choke to
Off
3. Disconnect
cord
Pull 1. Release handle
handle 2. Move Choke to
Off.