Controls And Features - Power Dynamics PD-5 Serie Manual De Instrucciones

CONTROLS AND FEATURES:

1. MICROPHONE INPUT
For XLR 3pole male connector
2. MICROPHONE INPUT
For Jack 6.33mm connector
3. LINE INPUT
For RCA left-right connector.
4. LINE INPUT
For XLR 3pole male connector.
5. LINE OUTPUT
For Jack 6.33mm connector.
6. LINE OUTPUT
For XLR 3pole female connector.
7. SWITCH 115VOLT or 230VOLT
Select the correct voltage to use the active
speaker. Standard setting 230Volt.
8. MICROPHONE LEVEL CONTROL
Volume control for the microphone
9. LINE LEVEL CONTROL
Volume control for the line input
10. VOLUME CONTROL
Volume/Master control for the speaker.
11. EQUALIZER TREBLE CONTROL
Tone control for the high tone.
12. EQUALIZER BASS CONTROL
Tone control for the low tone.
13. POWER LED
These indicator LED light up when you switch the
power on.
14. CLIP LED
These indicator LED will light up when amplifier are on max power. It can occur that these LED will lit up
now and then, this is not a problem. But if it lights up continually you need to adjust the volume down,
otherwise permanent damage to equipment might occur
15. MAINS POWER CONNECTOR / FUSE
This main fuse secures the speaker against defects. Replace this only with a fuse of same type and value.
16. ON/OFF SWITCH
For switching the speaker on and off. Always adjust the volume down to its minimum before switching this
speaker on