Craftsman 247.377300 Manual Del Operador página 23

Problem
Mower will not mulch grass
Uneven cut
Mower will not self propel
TROUBLESHOOTING
Cause
1. Wet grass.
2. Excessively high grass.
3. Dull blade.
1. Wheels not positioned correctly.
2. Dull blade.
1. Belt not installed properly.
2. Debris clogging drive operation.
3. Damaged or worn belt.
1. Do not mow when grass is wet; wait until dry to cut.
2. Mow once at a high cutting height, then mow again at desired
height or make a narrower cutting path.
3. Sharpen or replace blade.
1. Adjust cutting height lever on right front and right rear wheel to
same position.
2. Sharpen or replace blade.
1. Check belt for proper pulley installation and
movement.
2. Stop engine, disconnect spark plug boot,
and clean out debris.
3. Inspect and, if necessary, see your Sears Parts & Repair Center to
have belt replaced.
23
Remedy