Cleaning And Maintenance - Clatronic SM 3081 Instrucciones De Servicio

General Safety Instructions
Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing.
• The appliance is designed exclusively for private use
and for the envisaged purpose. This appliance is not fi t
for commercial use. Do not use it outdoors (except if it is
designed to be used outdoors). Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately. Do
not put it in water.
• When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull on the
plug, not the cable) if the appliance is not being used and
remove the attached accessories.
• Do not operate the machine without supervision. If you
should leave the workplace, always switch the machine off
or remove the plug from the socket (pull the plug itself, not
the lead).
• Check the appliance and the cable for damage on a regular
basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualifi ed
person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instruc-
tions".
Children
• In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
Caution! Do not allow small children to play with the foil as
there is a danger of suffocation!
• To protect children from the dangers posed by electrical
appliances, make sure that the cable is hanging low and that
children do not have access to the appliance.
Special Safety Instructions
• Make sure that the motor casing is not wet.
• Pay attention to the slowing down of the motor after shutting
off.
• The appliance is designed for the mashing and mixing of
food and drinks and for chopping together with the multi-
chopper.
• Short-time operating: use the device for no longer than
2 minutes with soft foods and no longer than 1 minute with
hard foods. Leave the device to cool down for at least
3 minutes before using again.
• Caution: The blade of the bar mixer is very sharp! It should
therefore be handled with extreme caution! DANGER OF
INJURY!
16
05-SM 3081_A5 16
• The appliance is designed to process only small quantities
of food! Fill the container with the maximum quantities speci-
fi ed in the table!
• Do not put hard foods such as ice cubes, nutmeg or large
pieces of chocolate into the container! The blade can be
damaged!
Scope of supply: 1 bar mixer with integrated blade
1 mixing vessel with lid (0.5 litres)
1 wall holder with attachment materials
First Use of the Machine
• Take out all the parts carefully out of the packing. Save
the packing and the inner packing material for the whole
duration of the warranty.
• Clean the device before using it for the fi rst time as descri-
bed in „Cleaning and Maintenance". Caution: The blade of
the bar mixer is very sharp! DANGER OF INJURY!
• After use the device should be stored in the wall holder
supplied.
Wall Mounting
• The mixing rod can also be attached to the wall using the
attachment kit supplied.
• In order to do this, measure the distance between the two
recesses on the back and drill two holes which are this
distance apart. Make sure before you start that you will not
damage any electrical wires hidden in the walls!
• Insert the motor housing with the mixing rod into the holding
device.
Using the Device
1. Fill the food to be mixed into the mixing bowl (max. 0.5
litres). Immerse the hand mixer completely.
2. Hold the device in such a way that you can operate the
ON/OFF button.
3. Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.
4. Press the ON/OFF button.
5. You can use pulse mode by pressing and releasing the
ON/OFF button at intervals.
6. The device switches off when the ON/OFF button is
released.
7. Pull out the plug from the socket after use. Clean and put
the device away as described in „Cleaning and Mainte-
nance".

Cleaning and Maintenance

• Always pull the plug out of the socket before cleaning!
• Clean the mixing beaker with water or in soapy water.
• In order to clean the mixing rod fi ll the mixing bowl with
water and operate the mixing rod as described under „Using
the Device". Then dry the mixing rod thoroughly. Caution:
The blade of the bar mixer is very sharp! DANGER OF
INJURY!
01.06.2006, 16:23:51 Uhr