Audio Outputs Connections - Ecler nuo 2 Manual De Instrucciones

3.2. Audio outputs connections

Out 1
Out 2
Rec
External FX
(Send and Return)
Monitor
- Master Output 1:
These stereo outputs feed the main house P.A. system through a XLR3 Balanced connections. The OUT 1 (26-27)
level is set at 0dBV (1V) but can be changed to +6dBV (2V) through internal jumpers. OUT 1 is controlled by
MASTER 1 (22) level potentiometer.
- Master Output 2:
Commonly used as an independent local "Booth" output for the DJ. This stereo OUT 2 (29) has unbalanced RCA
connections and its level is set at 0dBV (1V) but can be changed to +6dBV (2V) through internal jumpers. The
OUT 2 level controlled by the MASTER 2 (21) potentiometer.
- Recording Output:
This output pair uses RCA type connectors. REC (25) is placed on the rear connection panel. The nominal level of
the REC output is 0dBV(1V).
- External loop:
The RCA type EXTERNAL FX output SEND (23) and input RETURN (24) allow you to create an external loop with
any effect, sampler or sequencer device. The signal sent to EXTERNAL FX SEND output is selected PRE- or
POST-fader by the FX SEND toggle switch, while its associated knob determines the level.
The nominal levels of the SEND output and RETURN input is 0dBV(1V).
- Headphones:
In order to obtain a high performance, these should be of the high impedance type (200-600Ω). Plug them to the
MONITOR (20) output, in the front panel, by means of a standard 1/4" stereo jack. Sleeve is Ground, Ring is Right
Channel and Tip is Left Channel.
Main power amplifier
Booth/Room2 power amplifier
Recording
External effect device
(Input and Output)
Headphones
7