Bosch PR10E Instrucciones De Funcionamiento página 26

BM 2610021461 06-12_BM 2610021461 06-12.qxp 6/26/12 1:38 PM Page 26
5. Lightly press centering sleeve into sub-base
or templet guide to center.
6. Tighten the pan-head screws. Remove
centering sleeve.
CENTERING SHAFT
(optional accessory)
TEMPLET GUIDE
(optional accessory)
MAXIMUM BIT/CUTTER SIZE FOR
TEMPLET GUIDES
When using a templet guide, use only router
bit with cutters that are 1/16" less than the
internal diameter of the templet guide, such as
in the table below.
Bosch
Templet
Guide
RA1101
RA1103
RA1105
RA1107
RA1109
RA1111
RA1113
RA1115
RA1117
RA1119
RA1121
(optional accessory)
Bushing External
Depth Diameter
A
3/16"
9/64"
9/64"
5/16"
7/16"
3/16"
1/2"
3/16"
31/64" 13/16"
31/64"
7/16"
7. The precision centering of the subbase or
templet guide is complete.
CENTERING CONE – Used when centering
the subbase itself or wide templet guides.
CENTERING CONE
SUBBASE
USE WITH THREADED
TEMPLET GUIDES
Also available as an optional accessory is an
additional adapter, the RA1100, that allows
use of conventional threaded templet guides
with the Bosch quick-release system.
Internal
Diameter
B B
5/16" 1/4"
5/16" 17/64"
7/16" 3/8"
7/16" 3/8"
1/2" 13/32"
5/8" 17/32"
5/8" 17/32"
3/4" 21/32"
5/8"
1" 25/32"
1-3/8" 1-19/64"
-26-
CENTERING SHAFT
(optional accessory)
FIG. 47
PLUNGE BASE
Max
Bit/Cutter
Diameter
3/16"
13/64"
5/16"
5/16"
11/32"
15/32"
15/32"
19/32"
9/16"
21/32"
1-15/64"