Descargar Imprimir esta página

Vollrath Cayenne HPA1002 Instrucciones De Instalación página 3

Ocultar thumbs Ver también para Cayenne HPA1002:

Publicidad

Idiomas disponibles

Idiomas disponibles

TEST THE EQUIPMENT
Check the pressure of the incoming gas line
Before supplying gas to the regulator, check the pressure of the
incoming gas line.
The regulator can withstand a maximum pressure of 14" WC (1/2 PSI). If
the line pressure is beyond this limit, a step-down regulator will be
required. The arrow on the regulator body shows gas flow direction and
should point toward the appliance.
Check for Gas Leaks
NOTICE: Matches, candle flame, or any other potential source of
ignition shall not be used for this purpose.
1. Remove the main burner control knobs.
2. Use a flathead screwdriver to remove the screws on the front panel.
Remove the front panel to access the pilot burner control valves.
3. Locate the pilot burner control valve for each pilot light and turn it
OFF by turning the small forward-facing screw clockwise until tight.
4. Connect the equipment to the gas supply.
5. Apply soapy water to each connection.
6. Turn ON the main supply valve.
7. Look for bubbles at the connections.
8. Adjust the connections as needed.
Light the pilot burners
1. Wait 5 minutes to allow any gas to dissipate.
2. Hold a flame source over the desired pilot burner while slowly turning
its control valve screw counterclockwise,. Adjust the flame to the
desired intensity. Repeat for all pilot burners.
Test the main burners
After lighting all of the pilot burners, ensure that each main burner
functions correctly.
Reassemble the equipment
Allow the burners and surrounding surfaces to cool before reassembling
the equipment.
www.vollrath.com
The Vollrath Company, L.L.C.
1236 North 18th Street
Sheboygan, WI 53081-3201 U.S.A.
Main Tel: 800.624.2051 or 920.457.4851
Main Fax: 800.752.5620 or 920.459.6573
Customer Service: 800.628.0830
Canada Customer Service: 800.695.8560
AFFIX THE LABELS
1. Affix the Rating Plate, supplied in the kit, adjacent to the original on
the rear of the griddle.
2. Fill in the details required on the Installation Plate supplied in the kit,
and affix to the rear of the griddle.
CONVERSION BY QUALIFIED SERVICE AGENCY
THIS APPLIANCE WAS CONVERTED ON:
day
month
to LPG gas with KIT #:
by: C ompany
Address:
Which accepts the responsibility that this conversion has been properly made
3. Affix the Warning Label, supplied in the kit, near the regulator.
Technical Services
techservicereps@vollrathco.com
Induction Products: 800.825.6036
Countertop Warming Products: 800.354.1970
All Other Products: 800.628.0832
©
2017 The Vollrath Company L.L.C.
year
Part No. 350676-1 ml
6/3/17

Publicidad

loading