Programming With The Cs 2 / Cs3; Programming With The Ms 2 - marklin 70393 Manual Del Usuario

Setting the address and the mode of operation with the DIP switches:
• Setting the mode of operation with DIP Switch 10
Switch 10 off = fx (MM) / mfx
Switch 10 on = DCC
• fx (MM)/DCC Setting the address with DIP switches (See
table starting on Page 28)
!
Please note:
• Always do settings with the DIP switches when there is no
voltage present. The signal does not recognize the current
switch settings until the voltage is turned on.
• Basically, 2 addresses (pairs of buttons) are required to
switch the 70413 and 70414 signals. The second address is
assigned automatically as a sequential address. This sequen-
tial address cannot be selected at will.
Programming with the CS 2 / CS 3
fx (MM)
The CV programming must be done on the programming track.
Only one signal may be connected to the programming track at
a time.
The following CVs can be changed in fx (MM): CV 39, 40, 41, and
42. With CVs 41 and 42 the value must be divided by 4 in fx (MM),
because only the values 0-80 are allowed, for example:
255/4 = 64 (rounded).
During the programming procedure, the signal light will blink.
During programming with the Central Station, by contrast the
signal is switched. After the end of the programming procedure,
the signal is set at "Go".
The procedure for programming with the 6021 Control Unit
8
can be found at www.maerklin.de -> Service ->Technische
Informationen.
Please see the operating instructions for the control devices in
question for programming with other devices.
DCC
CV programming must be done on the programming track. Only
one signal may be connected to the programming track at a
time. The light on the signal will blink as a check during the data
transmission.
Please see the operating instructions for the control devices in
question for programming with other devices.

Programming with the MS 2

A new locomotive must be set up manually under MM2 or DCC in
order to program signals with the Mobile Station 2.
Please note that the signal to be programmed is then also set by
means of the coding switches to MM2 or DCC and to the same
address as the locomotive. This newly set up locomotive is only
required for the programming of signals. To do this go in the MS
2 menu to „Configure Locomotive" and then to „Program CV".
No other locomotive, signals, or turnout decoders may be
connected while the CV(s) are being programmed.
CV for fx (MM) and DCC
With fx (MM) the address can be set only with the DIP switches.
The values in parentheses are factory default settings.
CV Meaning
1 Address 1 - 255
9 Addresses 256 - 2040
Values
1-255 (1) only DCC
0-7 (0) only DCC