Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Clean The Water Inlet Filter (Fig. 22)
This screen filter should be checked periodically and cleaned if necessary.
1.
Remove filter by grasping end and removing it from water inlet of pump.
2.
Clean filter by flushing it with water on both sides.
3.
Re-insert filter into water inlet of pump. NOTE: Convex side faces out.
NOTE: Do not operate the pressure washer without filter properly installed.
STORAGE
Engine
Consult the Engine Owner's Manual for manufacturer's recommendations for storage.
TO PREVENT FUEL-RELATED PROBLEMS
1.
Add Ethanol Shield
stabilizer, fill the fuel tank with fresh gasoline. If only partially filled, air in the tank will promote fuel
deterioration during storage. If you keep a container of gasoline for refueling, be sure that it contains
only fresh gasoline.
2.
After adding a gasoline stabilizer, run the engine outdoors for 10 minutes to be sure that treated
gasoline has replaced the untreated gasoline in the carburetor.
3.
Turn the fuel valve to the OFF position.
4.
Continue to run the engine until it stops from the lack of fuel in the carburetor fuel bowl. Running
time should be less than 3 minutes.
Pump
The manufacturer recommends using pressure washer winterizing fluid when storing the unit for more than
30 days and/or when freezing temperatures are expected.
NOTE: Using pump guard helps provide proper lubrication to the internal seals of the pump regardless of
temperature or environment.
1.
Turn off pressure washer and disconnect hoses from pump.
2.
Unscrew bottle valve from Pump Guard bottle and remove seal.
3.
Screw bottle valve back onto bottle.
4.
Attach bottle to water inlet of pump.
5.
Squeeze bottle to inject contents into pump.
6.
With ignition switch off, simultaneously pull starter rope and squeeze bottle. Repeat until protector
fluid exits pump outlet. NOTE: This step may require two people.
ACCESSORIES
what was provided with this pressure washer as measured from the nozzle end of the wand to the gun trigger.
SERVICE INFORMATION
Do not return this product to your retailer. Please contact our customer service department at
1-855-504-5678 or www.campbellhausfeld.com
fuel stabilizer following the manufacturer's instructions. When adding a gasoline
TM
Risk of property damage. Use pressure washer winterizing fluid found at major retailers.
Other products could be corrosive and/or contain alcohol which may cause pump damage.
Risk of fluid injection. When using replacement spray wands or guns with this pressure washer,
DO NOT use a spray wand and/or spray gun/wand combination that is shorter in length than
The use of any other accessory not recommended for use with this tool could be hazardous. Use
only accessories rated equal to or greater than the rating of the pressure washer.
17
Publicidad
Tabla de contenido
