Trigger Safety Latch; Operation; Surface Preparation; Start Up - Maxus MX5222 Manual De Instrucciones Y Lista De Piezas

Assembly and Pre-Operation (Continued)
5. Install quick connect tip by pulling
back on collar and pressing in tip.
Release collar, make sure it completely
returns to its forward position and tip
is secure (see Figure 12).
6. Install quick connect tips to tip holder
and secure to the pressure washer
handle (see Figure 13).

TRIGGER SAFETY LATCH

In the engaged position, the trigger
safety latch prevents the gun from being
triggered accidentally. Push the latch fully
up to engage it (See Figure 14 and 15).
Always engage the trigger safety latch
when the unit is not in use.

Operation

SURFACE PREPARATION

The following cleaning procedure will help you organize your cleaning task and
ensures that you will achieve the best results in the shortest amount of time.
Remember to use the spraying / cleaning techniques mentioned in the following
section.
Before starting a pressure washer cleaning job, prepare the surface you intend to clean.
Clear furniture from the area and make sure that all windows and doors are closed
tightly. Also, protect all plants and trees near the cleaning area with a drop cloth. A
covering ensures that your plants won't be sprayed by the detergents.

START UP

ALWAYS use this start up procedure to ensure that the unit is started safely and
properly.
If water has frozen in the pressure washer, thaw the pressure washer in a
warm room before starting. DO NOT pour hot water on or into the pump;
internal parts will be damaged.
1. Check engine oil levels. Add oil as necessary.
2. Check fuel level. Add unleaded gasoline (rated 86 octane or higher) as required.
DO NOT refuel a hot engine. Refueling a hot engine could cause a fi re.
Use only fresh, clean regular or unleaded gasoline. Close the fuel shutoff
valve during refueling.
3. Attach a garden hose to the inlet side of the pump and connect it to the water
supply. Use a hose with an internal diameter (I.D.) of 5/8 in. (1.58 cm) and a length
of 50 ft. (15 m) or less.
Figure 12 - Inserting quick connect
tip
Engaged
Figure 14 - Trigger locked
Model MX5222
Figure 13 - Insert spray tips into rubber tip
holder
Figure 15 - Trigger unlocked
Disengaged
11