Kenwood DNN992 Guia De Inicio Rapido página 21

Ñ Unit
1) To prevent a short circuit, remove the key from
the ignition and disconnect the ¤ terminal of
the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the speaker wires of the wiring harness.
4) Connect the wiring harness wires in the
following order;
ground, battery, ignition.
5) Connect the wiring harness connector to the
unit.
6) Install the unit in your car.
7) Reconnect the ¤ terminal of the battery.
8) Press the <Reset> button. (P.4)
9) Perform the Initial Setup.
See First Step (P.7).
⿠Non-Japanese cars
⿠Japanese cars
6 or 7
Car Bracket
✎
NOTE
• Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (eg, the
sound may skip).
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
6 or 7
Ñ Trim plate
1) Attach accessory 8 to the unit.
⿠General Motors cars (DNN992)
1) Cut out accessory 4 to meet the shape of
the opening of the center console.
2) Attach accessory 4 to the unit.
Cut out to meet the shape of the
opening in the vehicle.
⿠Toyota/Scion cars (DNN992)
1) Cut out accessory 4 as illustrated.
Cutting line
2) Fold double-sided adhesive (accessory 5)
along the slit and attach it to accessory 4
cut-out against the center rib as illustrated.
Use 2 pieces of accessory 5 for 1 accessory
4 cut-out.
8
4
4
21
English ñ