Entering The Vehicle While It Is Running Via Remote Start; Using The "Quick-Stop" Feature; Service/Valet Mode - Ford Motor PowerCode Manual Del Propietário

Using the Remote Control Start Function (Con't)

Entering the Vehicle While it is Running via Remote Start:

1. Enter the vehicle. Do not press the brake pedal.
2. Insert the key into the ignition and turn to the ON position.
3. Press the brake pedal. The remote starter disengages and the vehicle will
operate normally.
Pre-Heating or Pre-Cooling the Interior of the Vehicle:
Before exiting the vehicle, set the temperature controls to the desired setting and
operation. After the system starts the vehicle, the heater or air-conditioning will
activate and heat or cool the interior to your setting.

Using the "Quick-stop" Feature:

If you want to make a short stop and leave your vehicle running (to keep the interior
warm or cool, for instance), the quick stop feature allows you to do this while keeping
your vehicle secure and your keys with you.
To engage quick stop:
1. Stop the vehicle and place the transmission in PARK.
2. With your foot off the brake pedal, press
lights will turn on, indicating that the vehicle is now running via remote start.
3. Remove the keys from the ignition and exit the vehicle.
Note: Do not leave children or animals unattended in the vehicle when using the
quick stop feature.

Service/Valet Mode:

In service mode, the remote start function is temporarily disabled to prevent the
system from unexpectedly starting the engine while being serviced.
To engage the service mode, turn the ignition key to the ON or RUN position and
press the and buttons together on the PowerCode remote control transmitter. .
The system will begin flashing the dash mounted status indicator in a double-flash
pattern indicating that the system is in Service mode.
To return the system to its normal operating mode, turn the ignition key to the ON
or RUN position and press the
transmitter again. The status indicator will shut off, indicating that the system is in now
in its normal operating mode.
Important Note: When taking your vehicle in for service it recommended that you
inform the service personnel that your vehicle is equipped with a remote control start
system.
4
101821-7.p65
on the remote control. The parking
and buttons on the PowerCode remote control
4 12/19/02, 9:55 AM