Lumme LU-2508 Manual De Instrucciones página 8

NOTE: When you use the hair clipper for the first time, the appliance may vibrate and make a snapping sound. This is normal and is a feature of the design.
EXTRA COMBS

Attachment comb № 1 leaves 3 mm hair length.

Attachment comb № 2 leaves 6 mm hair length.

Attachment comb № 3 leaves 9 mm hair length.
 Attachment comb № 4 leaves 12 mm hair length.

To attach a comb hold it with its teeth upward and slide it onto and along the clipper blade until the front of the comb firmly placed against the clipper blade.

When you use the clipper for the first time, cut only small portions of hair until you are accustomed to the cutting length with a certain comb attachment.

For even cutting, allow the comb attachment/cutter to cut its way through the hair. Do not force it through quickly. Also remember to comb the hair frequently to remove trimmed hair and check for
uneven strands.
BLADE ADJUSTMENT LEVEL
 The lever of blade adjustment is located near your thumb (if you are right-handed) so it can easily be adjusted while the clipper is in your hand.

The blade adjustment level adds versatility to your clipper. It allows you changing gradually the length of your haircut without a comb.

When the level is in the upper position, the blades make the shortest cut.

Pushing the lever downward gradually you could increase the length of haircut.

In the lowest position of the lever hair length is approximately the same as after № 1(3mm) comb.
 The level also extends the use of your blades as different cutting edge is used in each setting.

To remove stuck hair move rapidly the lever from lower to upper position several times.

If your clipper stops to cut and removing of stuck hair doesn‟t help, replace the blades with new.
TIPS

Cut the hair in a relaxed and slow manner. Use short strokes only to work gradually over the head.
 Always take off a little at a time.

Cut dry hair only as it is easier to control haircut length.

Don‟t cut fast.

Don‟t press hard on the clipper.

If you cut for the first time start with maximum comb attachment.
STEP 1 – NAPE AND NECK

Set № 1 (3 mm) or № 2 (6 mm) comb.

Hold the clipper cutting edge up and begin the haircut. Start at the center of the head at the base of the neck (fig. 1).

Slowly lead the clipper, working upwards and outwards, through the hair, trimming just a little at a time.

Continue to cut back area from the bottom of the neck upwards to the top of the ears.
STEP 2 – BACK OF THE HEAD

Set № 3 (9 mm) or № 4 (12 mm) comb and cut the back of the head (fig. 2).
STEP 3 – TEMPLES AND SIDE OF THE HEAD

Set № 1 (3 mm) or № 2 (6 mm) comb and cut hairs in temples area.
8