Lumme LU-2501 Manual De Instrucciones página 11

BLADES ALIGNMENT

Blades must be realigned if they have been removed for cleaning or replacement.

To realign the blades simply match the upper and bottom blades teeth up, point for point.

End of top blade teeth should be approximately 1.2 mm back from bottom blade. Compare your clipper blades with the figure.

If blades are set incorrectly, add few drops of oil to the blades, switch on the clipper for a few seconds, then switch it off and unplug.

Loosen screws slightly and adjust the blades. Tighten screws after blade is aligned.
 If the hair clipper buzzes, then adjust it using the screws (on the device). Before adjusting oil the blades.
CLEANING

Mind to clean the appliance regularly for appliance and blades long life.

Ensure that the appliance is switched off.

Remove cut hair from the blades with the brush.

Wipe the body of the hair clipper with wet cloth. Dry the appliance.

Don‟t immerse the appliance in water or another liquid.

Don‟t use chemical or abrasive cleaners.
BLADES LUBRICATION

Mind to oil the blades of the clipper every few haircuts for appliance and blades long life.

Use only oil that is in set.
SPECIFICATION
Model Power supply
LU-2501 220-240 V, 50 Hz
LU-2501 220-240 V, 50 Hz
LU-2506 220-240 V, 50 Hz
LU-2507 220-240 V, 50 Hz
Power Net weight / Gross weight
12 W 0,38 kg / 0,50 kg
12 W 0,38 kg / 0,50 kg
12 W 0,38 kg / 0,50 kg
12 W 0,38 kg / 0,50 kg
Package size (L х W х H)
180 mm х 58 mm х 240 mm
Producer:
WENZHOU N. AND A. FOREIGN TRADE CO. LTD.
180 mm х 58 mm х 240 mm
16/F, INTERNATIONAL TRADE CENTRE, NO.8 LIMING ROAD WEST,
WENZHOU, CHINA
Made in China
180 mm х 58 mm х 240 mm
180 mm х 58 mm х 240 mm
11