FUXON R-232 ND Instrucciones De Funcionamiento página 3

Technical facts and references
With red COB LEDs (24 pcs), standlight via
u
capacitor
Tested and approved in accordance with
u
the German Road Traffic Licensing Regula-
tions (StVZO)
The reflector surface of the taillight must
u
be oriented vertically to the road and at a
right angle to the longitudinal axis of the
road.
Nominal performance: 0,6 W
u
Input voltage: 6V AC
u
Connecting the rear-light:
Pull the + and – slide-appliance out of the housing (1), insert the designated cables in the
particular port and then push the slide-appliance back into the housing again (2).
1
DC AC 6 V 0,6 W
Slide
Power cable +
Atachment of the rear-light:
Mounting hight: 250-1200 mm
u
Attach the rear light with the designated
u
screws,nuts and washers to the carrier of
the bicycle.
When attaching the tail light, make sure
u
that the screws are tightened so tightly
that the light can not.
3
Screw:
M5 x 15
R-232
Power cable -
24 COB LED
REAR LIGHT »R-232 ND«
PLEASE NOTE
If an LED fails, the entire light unit must
be replaced!
Important:
Rear-light and headlamp must only be
switched on at the same time in case they
are run by one alternator.
This rear-light should only be connected to a
frontlight with separate on and off techno-
logy.
2
DC AC 6 V 0,6 W
Slide
Power cable +
IA 150R00 0005
K 1759
K 1793
R-232 R-232
DC AC 6 V 0,6 W
DC AC 6 V 0,6 W
Input
COB Ring rot (24 St.)
vehicle`s longitu-
dinal axis
GB
R-232
Power cable -
Before every
journey, en-
sure that the
headlight is
not covered.