Start Up Instructions - Garland MONTANA 008 Manual De Instrucciones

6. START UP INSTRUCTIONS

6.1. LIST OF MATERIALS
This machine includes the following items that you will
find inside the box:
• Engine.
• Chain protector.
• Rod.
• Chain.
• Claw
• Spark plug wrench.
• Screwdriver
• Instruction manual.
Due to the quality controls carried out at the factory,
it is unlikely that your tool will have any defective or
missing part.
If you find any damaged or missing parts, do not use
the machine until the defect has been repaired or
all the missing pieces replaced. Using the machine
without all of its parts or with defective parts can
cause severe personal injury.
6.2. INSTALLATION OF THE ROD AND CHAIN
The chain of the chainsaw has very sharp teeth.
Always wear protective gloves to avoid accidentally
cutting yourself.
1. Check that the chain brake is not activated by
pulling the chain brake lever back.
2. Unscrew nut (1) and
remove (3) the cover of
the chain (2). Once you
remove the cover, remove
the adjustment guard (7)
if it exists.
4. Place the chain (6)
on the sprocket (3) while
adjusting the chain (7)
around the the rod (4)
and mount rod (4) on the
machine.
Adjust the chain tension by
matching the pivot into the
hole in the rod.
Pay attention to the correct position of the chain.
The correct position of the chain is the following:
5. Place the chain cover (2) placing firstly the two clips
and tighten lightly the nut with your fingers (1).
6. Regulate the chain tension
using the tensing screw so that
when you pull the chain in the
center of the rod it can boost
but not to get out of the guide
rod and returns to its position within the guide once
you let go.
47/160
English
2
1
3. Position the claw (3)
as indicated in the
drawing, tighten the
screws to fix it
3
3
6
5
4