Replacing The Battery - MAXSA Innovations 44640 Instrucciones De Montaje Y Funcionamiento

Motion-Activated Solar Security Light
Walk slowly around the area of detection, changing your walking pace until the light comes
on. If light does not come on, you may need to adjust the angle of the sensor unit. Make
adjustments as needed until the desired level of sensitivity is reached. Re-adjust the TIME and
LUX dials when complete.
LIGHT LEVEL ADJUSTMENT (LUX)
The LUX dial controls the natural light level that triggers the Solar Security Light and prevents
the light from operating during daylight hours.
Your Solar Security Light comes preset for activation at dusk. If you want your security light
to activate when it is still light out, move the dial towards the sun (). If you only want your
security light to work when it gets dark, move the dial towards the moo ( ).

REPLACING THE BATTERY

When the charging ability of the battery pack decreases, you can replace it with a new
3.7V/4.4 Ah Lithium-Ion battery pack. Follow the steps below when replacing the battery
pack.
First remove the main unit from its mounted surface and unplug the solar panel.
1.
Move the power switch on the main body to the OFF position.
2.
Remove the four (4) screws on the back of the main unit that hold the halves together.
3.
Once the unit is open, carefully remove the bracket holding the battery pack in place
4.
by unscrewing the two (2) screws as indicated in the diagram above.
Carefully unplug the battery pack from the unit. Be sure to pull by the base of the plug.
5.
Do not pull the plug by the wires as this may damage the unit.
Carefully remove the battery pack and replace with a new 3.7V / 4.4Ah Lithium Ion
6.
battery pack obtained from MAXSA Innovations. The plug will only fit in one orientation.
Do not force the plug into place as this may damage the unit. If it does not fit, rotate
the plug until it matches with the receiving end on the circuit board.
Replace the bracket to hold the battery pack in place by using the two (2) screws
7.
removed in step 4, taking care not to damage any cables.
Re-assemble the main unit by screwing the two (2) halves of the main body together
8.
securely.
Once assembled, mount your Solar Security Light to its original surface location.
9.
10. Repeat the steps in the "Before first time use of your Solar Security Light" section on
page 4 to ensure your new battery is fully charged.
Battery Pack
www.maxsainnovations.com
Part #s 44640 & 44641
5