Information Codes - Samsung WF431AA Manual De Usuario

INFORMATION CODES

The washer may display information codes to help you better understand what is occurring with your
washer.
CODE SYMBOL
dc
dL
dS
FL
Hr
LE
LE(1E)
LO
nd
nF
WF431ABP-03016A_EN.indd Sec6:27 WF431ABP-03016A_EN.indd Sec6:27
MEANING
Unbalanced load prevented your
washer from spinning.
Door is unlocked when washer is
running.
Door is open when washer is running.
Your washer failed to lock the door.
Water temperature control problem.
(Heater control problem)
Your washer has tried to fill, but has not
reached the proper water level.
Leak problem or Waterlevel Sensor is
not normal conditon.
The door will not unlock.
Your washer is not draining.
It can also mean that the unit senses a
small clog while draining.
Your washer has tried to fill but was
unsuccessful.
Check if the hot water supply hose is
connected.
SOLUTION
Redistribute the load, press the Start/
Pause button.
Press the Power button to turn off your
washer, then restart the cycle. If the
code reappears, call for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Close the door tightly and restart the
cycle.
If the code reappears, call for service.
Call for service.
Call for service.
Call for service.
Make sure the door is firmly closed.
Press the Power button to turn off your
washer, then turn it on again. If the
code reappears, call for service.
Clean the drain filter. Then, clean the
debris filter (See page 23).
If you are in the middle of a wash you
can try this first:
1. Turn off the unit for 10 seconds and
then turn it on again.
2. Select the Spin Only cycle (See page
16).
3. Press the Start/Pause to drain the
water.
If it still does not drain, call for service.
Make sure the water faucets are open all
the way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
If you use a Flood Safety Device, then
please remove the device and connect
the water hoses directly to the unit.
You must connect the hot water supply
hose because hot water is supplied by
the Auto Temperature Control (A.T.C.)
function if the temperature of the cold
water is lower than 59°F.
Troubleshooting _27
2011-01-11 ¿ÀÈÄ 3:18:04 2011-01-11 ¿ÀÈÄ 3:18:04