AIRSTAGE AB-A12L Manual De Funcionamiento página 6

CLEANING AND CARE
CAUTION!
Cleaning the air filter
G AB A12/14/18/24L
1. Remove the air filter.
1 Pull out both sides and the center of the intake grille.
2 Pull the air filters upward to remove them.
About 30 mm
Arm
Intake Grille
2. Cleaning
Cleaning the Air filter
Remove dust with a vacuum cleaner or by washing. After washing, be sure to allow it to dry thoroughly in a shady place
before reinstalling.
3. Re-attach the air filters to the intake grille.
1 The air filters fit onto the inside of the intake grille.
2 The bottom edges of the air filters should fit into the filter brackets.
3 The air filters should be pushed down so that their top edges fit under the projections at the top of the intake grille.
4 Push in both sides and the center of the intake grille.
Air Filter
1 2
Filter bracket
En-5
G Before cleaning the unit, be sure to stop the unit and disconnect the power supply.
G Do not stand on an unstable platform when cleaning.
G When removing and replacing the air filters, be sure not to touch the heat exchanger, as per-
sonal injury may result.
G Be sure the intake grille is installed securely.
G When cleaning the unit's body, do not use water hotter than 40 °C, harsh abrasive cleansers, or
volatile agents like benzene or thinner.
G If dirt is allowed to accumulate on the air filter, air flow will be reduced, lowering operating
efficiency and increasing noise.
AB A12/14/18/24L
G
During periods of normal use, the air filters should be cleaned every two weeks.
AB A30/36/45/54L
G
During periods of normal use, the air filters should be cleaned every four weeks.
Side Panel
Hook
Notch
Arm
3
Handle
Intake Grille
4
4
4
2
Air Filter
Bracket
Base