Jack Assembly; Attaching The Carrying Handle; Assembling The Lifting Lever - autoXS FLX-WH-01US Manual Del Usuario

Jack assembly

Jack assembly

Attaching the carrying handle

On each side of the lifting lever socket
the carrying handle
1. Place one of the carrying handle's "eyes" over the carrying
handle nut
2. Carefully stretch and fi t the carrying handle's other eye
into place. You may need to exert a bit of pressure on the
carrying handle's eyes to push them properly into place.
The carrying handle should now sit snugly in place (see
Fig. A).
3. Before carrying the jack, make sure the carrying handle
fi ts snugly in place by pushing the jack back and forth. The
carrying handle should stay securely attached during this.
If it does not, re-attach the carrying handle.

Assembling the lifting lever

1. Align the 2 halves of the lifting lever
pin in one section with the drilled hole
10
section (see Fig. B).
2. Push both pieces together until the locking pin "clicks"
(see Fig. B).
To disassemble the lifting lever, remove the lifting
handle from the jack. Push down on the locking pin to
separate the two halves, then snap each half into place in
the lifting lever clips
and B).
14
needs to be attached.
6
(see Fig. C).
8
on either side of the jack (see Fig. A
9
is a nut to which
4
with the locking
5
in the other
11