Maintenance & Servicing - HOLL'S Multiwave 3 Manual De Instalación

Maintenance & servicing
Maintenance
IMPORTANT:
Disconnect the cabin's power supply cable before undertaking any work.
Problems identified
No indicator light displayed
on the control panel.
One or more infrared panels
do not heat up
Sauna gives off a smell
Sauna light fitting no longer
work
A speaker is not working
MP3 player not working
Screen shows a wrong temperature
Servicing
1. Disconnect your sauna.
2. Use a vacuum cleaner to remove dust from crevices in the woodwork.
3. Clean the cabin with a damp cotton cloth and use a small amount of soap if necessary. Rinse with a damp cloth.
4. Clean the glass with a window / glass cleaner and a soft colth.
5. Please check and fasten the screws of the bench once every three months to prevent the play or fall of the seat.
IMPORTANT:
Do not use benzene, alcohol, chemical agents or strong detergents on the sauna since chemical products can damage the
wood. Do not spray water on your sauna.
14
Possible reasons
Power supply cable disconnected
The general power supply is cut
Fault in power supply unit
The infrared panel button is
positioned to the middle (
The infrared panel's cable is
disconnected
One of the infrared panels is defective
Temperature of the panels or their
cables is too high
Ribbon LED cable not fully plug
Ribbon LED is defective
Speaker cable disconnected
Speaker defective
Power supply cable disconnected
MP3 player not switched on
Temperature sensor is incorrectly
connected or defective
Solutions
Check power supply cable connection
Check that the switchboard and wall plug
are working
Contact your dealer
Push the button panel to the right or left
according to your desire.
).
Check cable connections
Replace the infrared panel with an original
component supplied by the manufacturer
Switch off power supply and contact your
dealer
Plug the cable
Contact your dealer
Reconnect the cable
Contact your dealer
Reconnect power supply cable
Check the DC power supply cable and
replace if required
Reconnect the cable or replace the sensor