UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. Avoid positioning the appliance in direct
sunlight or damp areas.
3. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
4. Insert the slide-out shelf/shelves at the desired
levels and place the smaller shelf/shelves on
the floor of the appliance.
5. If necessary, adjust the screw feet of the
appliance to make it level.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Operation
Control Panel
The control panel is located below the doors on the
front of the appliance.
Cooling Light
4
GH130-GH131_ML_A5_v2_20180411.indb 4
Defrost Light
Turn On
1. Close the doors of the appliance.
2. Connect the appliance to a mains power
supply.
3. Switch on the Power switch [I].
Note: The Cooling Light is
illuminated when the appliance
is chilling the interior cabinet.
How To Change The Set
Temperature
The default operating temperature is 2 °C. To
change the operating temperature:
1. Press SET for 3 seconds
2. Press
or
until
SET to confirm.
3. You are now in the menu and will see
blinking.
4. Press
to show
point). Press SET to confirm.
5. Adjust temperature to required temperature.
Press SET to store set point.
6. Unit will resume normal operations after 30
seconds.
Manual Defrost
•
POLAR Back Bar Chillers feature an automatic
defrost. However, should the appliance require
an additional defrost period press and hold the
button for 3 seconds.
•
Press and hold the
button for 3 seconds to
stop defrosting.
Note: If a manual defrost is
started this resets the automatic
defrost timer. During defrost
periods the Defrost light is
illuminated.
starts to blink.
is shown. Press
(temperature set
2018/4/11 17:47