Technical Data - Clipster DeloX Instrucciones De Uso

Replacing the clipping head:
The clipping head is a wear part. Despite good care, the cutting performance will diminish. At this point, the clipping head should be replaced.
The clipping head can be ordered individually as a spare part (ref. no. 18477). When replacing the clipping head, you can remove the residue
hair within the clippers using the brush. Press in the centre of the shearing blades to remove them (fig. 7). Place the new clipping head back
onto the clippers as shown in fig. 8. Make sure that the locking mechanism is positioned properly and press the clipping head onto the device
until it engages.
Cleaning the device:
Wipe off your device occasionally using a moist cloth, then rub it dry.
5. Troubleshooting
What to do, when...
... the device cannot be switched on?
• is the battery empty? Connect the power pack and charge the clippers
• is the clipping head dry? The clipping head must be oiled
... the clipping head does not operate smoothly?
• the clipping head must be oiled
• the top and bottom blades can become stuck when not in use for longer periods of time
... the charging display does not light up when charging?
• make sure that the power pack is connected properly
... the device switches off by itself?
• the battery is empty. Charge the clippers
... the battery can no longer be charged?
• the battery or the power pack is defective. The power pack can be re-ordered. If the battery is defective, then the device must be
disposed of properly.

6. Technical data

Art. No.
Motor speed
Charging time
Shearing time
Weight
Input voltage
Frequency
Battery capacity
Current consumption
Ambient temperature charging process/use
Protection class
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please consult the valid national regulations.
The device must not be disposed of in household waste. In accordance with the stipulations of the EU Directive on the Disposal
of Electrical and Electronic Devices, the device can be disposed of free of charge at the local waste collection or recycling centre.
Alternatively, it can be returned to retailers who offer a collection service. The proper disposal helps to ensure environmental
protection and prevents any adverse effects on human health and the environment.
CE-symbol / CE-conformity declaration
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental requirements
and other relevant stipulations and regulations. The CE mark confirms compliance with the Directives of the European Union.
Clipper Power pack
18463 18468
4000/5000/6000 rpm -
300 min -
300 min -
242 g 69 g
5V DC 100-240 V
- 50/60 Hz
2200 mAh -
max. 2000 mA 0.2 A
0°C - 40 °C 0°C - 40 °C
III II
17