Care And Service; Troubleshooting Guide; Warranty; Technical Data - Kärcher BLV 18-200 Battery Manual De Instrucciones

WARNING
Movement of the fan wheels and mulching blades
Incision injuries
Wear protective gloves.
Keep your fingers away from the fan and mulching
blades.
d Remove the upper blower and suction pipe from
the motor casing.

Care and service

Cleaning the device
WARNING
Uncontrolled startup
Risk of injury
Remove the battery pack from the device during work
breaks and before carrying out any service or care work.
ATTENTION
Incorrect cleaning
Damage to the device
Clean the device with a damp cloth.
Do not use solvent-based cleaning agents.
Do not immerse the device in water.
Do not clean the device with a hose or high-pressure
water jet.
1. Switch off the device.
2. Remove the battery pack (see chapter Removing
the battery pack).
3. Clean the exterior of the device with a soft, dry cloth
or with a brush.
Illustration O
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Fault
The device does not start
up
The device stops during
operation

Warranty

The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
24

Troubleshooting guide

Cause
Battery pack is not inserted correctly.
Battery pack is empty
Battery pack is defective.
Safety button did not trip during assem-
bly.
The battery has overheated
Motor has overheated
Removing blockage
Note
Do not try to remove the fan or mulching blades. If re-
moval of the mulching blades or fan is required, contact
an authorised Customer Service centre.
WARNING
Movement of the fan wheels and mulching blades
Incision injuries
Wear protective gloves.
Keep your fingers away from the fan and mulching
blades.
1. Switch off the device.
2. Remove the battery pack, see Chapter Removing
the battery pack.
3. Remove the collecting bag, see chapter Remove
the collecting bag.
4. Remove the upper blower and suction pipe.
Illustration N
a Unscrew the fixing screw on the suction pipe.
b Remove the suction pipe fixing screw.
c Pull out the motor casing locking pin as far as
possible.
d Remove the upper blower and suction pipe from
the motor casing.
5. If necessary, remove any blockage from the pipes.
6. If necessary, remove any blockage in the adapter.
7. If necessary, remove any blockage from the con-
necting piece.
8. Clean the openings of the motor casing.
As the battery pack ages, even if it is looked after, its ca-
pacity reduces such that the full run time will no longer
be reached when fully charged. This does not indicate a
defect.
Rectification
 Push the battery pack into the mounting
until it latches into place.
 Charge the battery pack.
 Replace the battery pack.
1. Unscrew the suction pipe fixing screw once
again.
2. Tighten the suction pipe fixing screw until a
clicking sound is heard.
The safety button has tripped.
 Stop working and allow the battery to cool
down to normal battery temperature.
 Stop working and allow the motor to cool
down.

Technical data

Device performance data
Nominal voltage
Average air speed of cordless
blower
Average air speed of cordless
blower (turbo mode)
Maximum theoretical air speed of
cordless blower
Maximum theoretical air speed of
cordless blower (turbo mode)
English
V 18
km/h 152,9 +/-
10 %
km/h 186,7 +/-
10 %
km/h 186,7 +/
- 10 %
km/h 262,9 +/
- 10 %