Installing The Vanishing Edge; Tm Strainer; Installing The Garbage Disposer (Optional) - Glacier bay QK011 Guía De Uso

Installation (continued)
INSTALLING THE VANISHING EDGE™ STRAINERS
NOTE:
If you are installing a garbage disposer (not supplied), do not install the strainer.
Included with this item is a garbage disposer adaptor. This will replace the
flange from your garbage disposer. Install the garbage disposer according to the
manufacturer's installation instructions replacing the flange for the adaptor.
- Apply a small amount of plumbers putty (not included) in the notch
around the drain hole of the sink (A) .
- Connect the upper strainer body (3) and the strainer ring (4), and insert
them into the drain hole from the top of the sink (A) .
- Connect the strainer gasket (5) and lower strainer body (6), and insert
them into the drain hole from underneath the sink (A) .
- Insert the strainer screw (2) through the entire assembly, from the upper
strainer body (3) to the lower strainer body (6). Tighten with a flathead
screwdriver .
- Connect the plastic flange (7) and the tail pipe (8), and thread the
connecting nut (9) through the tail pipe and flange up to the lower
strainer body (6) . Tighten the connecting nut by hand .
NOTE:
The plastic flange (7), tail pipe (8), and connecting nut (9) are not supplied.
INSTALLING THE GARBAGE DISPOSER
NOTE:
If you are installing a garbage disposer (not supplied), do not install a
strainer in the sink. Adaptor (F) is intended for use with metal waste
disposer mounting flanges.
- To install a garbage disposer, place the rubber ring (G) around
the underside lip of the adaptor (F) .
- Insert the adaptor (F) into the drain hole of the sink (A) .
- Install the garbage disposer to the adaptor (F) according to the
garbage disposer manufacturer's installation instructions .
A
F
A
G
11
Please contact 1-855-HD-GLACIER for further assistance .
1
2
3
4
5
6
7
8
Not supplied
9
HOMEDEPOT .COM/GLACIERBAY