Crunch GROUND POWER GPX2200.1D Manual De Uso página 11

FIGURES
(P. 28-31)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1) Mono audio input (OUT), leading to an additional GPX2200.1D
(1b) Mono audio input (LINE INPUT), coming from an additional GPX2200.1D
(2) Audio signal inputs
(3) Gain level controller
(4) Phase Shift controller
(5) Subsonic filter controller
(6) Low Pass filter controller
(7) Bass Boost controller
(8) Connector for the included bass level remote controller
(9) Power-/Protection-LED
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1) GND terminal for the ground
(2) REM terminal for the turn on connection
(3) +12 V terminal for the positive-connection of the battery
(4) Vehicle's battery
(5) In-Line Fuse (not included in the scope of delivery)
(6) Turn on wire from the head unit or the electrical antenna
(7) Fuse
1-CHANNEL OPERATION MONO 1 SUBWOOFER (FIG. 3)
If you want to run the amplifier with the 2 line output channels from the head unit to drive a subwoofer, connect
the following setup:
(1) To the head unit, line output left or subwoofer output
(2) To the head unit, line output right or subwoofer output
(3) Bass level remote controller
(4) Subwoofer (1 - 8 Ω)
1-CHANNEL OPERATION MONO 2 SUBWOOFERS (FIG. 4)
If you want to run the amplifier with the 2 line output channels from the head unit to drive two subwoofers, con-
nect the following setup:
(1) To the head unit, line output rear left or subwoofer output
(2) To the head unit, line output rear right or subwoofer output
(3) Bass level remote controller
(4) Subwoofer 1 (2 - 8 Ω)
(5) Subwoofer 2 (2 - 8 Ω)
MASTER/SLAVE OPERATION WITH TWO GPX2200.1D (FIG. 5a-5c)
If you want to run amplifier 1 (MASTER) with two line output channels from the head unit and the additional
amplifier 2 via BRIDGE OUT (Fig. 1,1a), connect the following setup:
(1) To the head unit, line output left
(2) To the head unit, line output right
(3) Bass remote control to adjust the bass level out of the driver's seat
(4) RCA Connection between MASTER and SLAVE
11