Rear Panel Description - ZKX Audio MT 250 Manual El Usuario

REAR PANEL DESCRIPTION

* Only models MT 250, 500, 1000, 1500, MTs 700 y 1400.
1 - POWER CORD
All the units are provided with an appropriate plug and cable according to the AC required voltage. This product is equipped with a ground plug which
must not be removed for safety reasons. Please check AC voltage before connecting the plug.
2 - FUSE
It is provided with a fuse to protect the power supply from excessive current. It is located in the rear part of the panel next to the power cord.
3 - OUTPUT CONNECTORS
It is provided with a pair of posts for the exit connection to each channel. The speakers can be easily connected using banana, spade or nude cables.
The spade plugs and the nude ones should be both firmly screwed to avoid a short circuit.
4 - FAN
This turbine insures adequate temperature inside the equipment. Keep the frontal and rear ventilations clean to allow a complete airflow. Hot air will
pass through the front of the amplifier, so as not to heat the interior of the rack. Make sure of the fact that fresh air must enter fully into the rack.
5 - INPUT CONNECTORS
The entry amplifier offers the entry connectors Neutrik Combo, 6,5 XLR 3 pins.
6 - SWITCH STEREO / BRIDGE
Turn off energy before changing the operation manner. In the Stereo operation , each channel of the amplifier operates independently from their own
signal and speakers. In the bridge operation, both channels can be configured to handle a singular load with double energy. Use the following safety
procedure when pressing stereo or bridge mode:
CAUTION
A) ·TURN OFF THE AMPLIFIER.
A
B) ·FOR THE MT SERIES CHOOSE A SPEAKER OF NO LESS THAN 8 OHMS OF IMPEDANCE,
B
IN THE RED EXIT TERMINALS (+) OF THE AMPLIFIER. FOR THE MTS SERIES SELECT A
SPEAKER OF NO LESS THAN 4 OHMS OF IMPEDANCE, IN THE RED EXIT TERMINALS OF
THE AMPLIFIER.
C C) MAKE SURE THAT THERE EXISTS ONLY ONE ENTRY SIGNAL CONNECTED TO THE CH1.
D) PUT THE AMPLIFIER ON BRIDGE MODE.
D
E E) TURN THE GAIN CONTROLS OF CH1 AND CH2 TO THE LEFT EXTREME AND THEN LIGHT
THE AMPLIFIER.
F) GAIN CONTROL WILL BE PRODUCED BY CH1.
F
- page 12 -
USER`S MANUAL MT and MTs SERIES
USER`S MANUAL MT and MTs SERIES
1
POWER SUPPLY
2
FUSE
3
OUTPUT CONNECTORS
4
FAN COOLER
5
INPUT CONNECTORS
6
SWITCH STEREO / BRIDGE
#12